Coating for basins of fountains of tanks Elastomeric Pool (3kg.) White

The finish one -component coating for the waterproofing of pools, tanks, fountains.

Elastomeric Pool - applied in liquid form, finish one -component coating based on a subpolimal of a synthetic rubber of a new generation for waterproofing building structures and seamless finish waterproofing coatings in pools, tanks, artificial reservoirs, fountains, etc. After drying, it forms a very strong, waterproof, high -elastic membrane without a pungent odor. The coating has extraordinary resistance to ultraviolet light, reagents used to disinfect water, moderate concentrations of chlorine, acids and alkalis. It is used for repair and waterproofing on old and new grounds, including concrete, metal, as well as PVC, EPDM and TPO membrane.

AREAS OF USE:

Waterproofing of pools, industrial containers, water intake gutters and trays, fire reservoirs, artificial reservoirs, showers, and fountains

BENEFITS:

Overlaps cracks, including mobile

Easily applied (brush, roller, airless spraying)

Expanded range of use

Resistant to standing water and UV radiation

Has a high degree of abrasive wear

Repair isivable (easy detection and repair of mechanical damage)

Resistance to the formation of fungus and mold

SPECIFICATIONS:

Density: 1.0 kg/l

The speed of curing (you can walk): 8 - 12 hours. at +20 ° C, 50% TO. moisture.

Hardness (a firmness scale along Shor - a): 65

Full set of strength: 7 days

The content of dry substances: at least 50%

Adhesion to concrete: & gt; 3.2 n/mm² (kogezion rupture)

Strength strength: & gt; 3.0 n/mm²

Stretching for rupture: & gt; 500%

Operating temperature: -60 ° C - +160 ° C

Application temperature: -20 ° C - +35 ° C

CONSUMPTION:

1-2 layers: 0.5-1.5 kg/m²

Factors such as porosity, temperature, humidity, application method and project requirements can affect the consumption of material

Surface preparation:

All parts of the surface should be dry and clean, free of dirt, fat, oil, loose rust or concrete, formwork lubrication, surface chemicals and other pollution, which can weaken the adhesion of the coating. The surface should not have sharp protrusions and ribs. New concrete should be withstand at least 28 days before applying the coating. The weakly holding concrete particles, cement milk should be removed, surface defects should be repaired. Cracks, adjacents, communication sites should be repaired and stacked with the help of specialized repair compositions. Mobile cracks, cracks and/or voids, the adjoining should be repaired and reinforced with Elastomeric Fabric repapsulated in Elastomeric Pool. A strip of Elastomeric Fabric reinforcing fabric is 15 and 30 wide, cm and corresponding to the processed section of the length, is shed in a layer of raw, applied to the Elastomeric Pool with a brush or roller until the fabric is saturated. On top, “wet along the wet”, a sufficient amount of Elastomeric Pool is applied to fully perplify the reinforcing fabric, avoiding the formation of non -color, wrinkles and air pockets.

The preparation of the surface affects the quality of the coating and its durability.

Application:

Before use, mix the material thoroughly with a low-speed mixer for at least 2-3 minutes. Apply the Elastomeric Pool to the surface with a roller, brush or an airless spraying apparatus (pressure 180-220 bar, a nozzle 29, 31 or 34) with a continuous layer without gaps. In the case of applying the material by an airless spray, you can dilute with xylole a maximum of 10%. The application temperature is from - 20 ° C to + 35 ° C.